Manual Reference Pages - PFSOUTIMGMAGICK (1)
pfsoutimgmagick - Write images or frames using Image Magick library
pfsoutimgmagick [--linear] [--quality <val>] [--bit-depth] [--frames <range>]) <file> [<file>...]
This command can write images or frames in the multitude of image
formats supported by the ImageMagick library. This includes but is not
limited to: BMP, JPG, PNG, GIF, EPS, TIFF, DPX. See the manual page of
ImageMagick for the full list of available formats.
pfsoutimgmagick reads images or frames in pfs format from
the Standard Input and writes them under the specified file name(s).
The input of pfsinimgmagick must be within 0-1 range. If LUMINANCE
tag set is set to RELATIVE or ABSOLUTE, the linear
values will be gamma corrected, assuming sRGB color space. Use --linear
switch to disable gamma correction.
The images are stored using the bit-depth for which the ImageMagick
library was compiled (default is 16 bit). Note that some formats (for
example JPEG) do not support encoding more than 8 bits per color
channel. To use higher bit-depths, store images in the PNG format.
This command stores ALPHA channel if it is present in the pfs stream.
Each file name can contain a %d pattern, which is substituted with
frame numbers. The pattern has the same syntax as C printf
command. For example, you can use %04d to make the frame number four
digit with proceedings zeros. You can select the frames using the
following options (the options must be always given after the file
--frames <range> |
Range is given in mathlab / octave format:
Frame numbers start with
startframe (default 0), are increased by
step (default 1) and stop at
endframe You can skip one of those values, for example
1:100 for frames 1,2,...,100 and
0:2: for frame 0,2,4,... up to the last file that exists.
--srgb, -s |
Apply the sRGB non-linearity (approximately 2.2 gamma) before writing
a file. This can be used instead of using pfsgamma -g 2.2 to
store the result of some tone-mapping operators. The option will
compress contrast to make sure that tone values are properly shown on
a display. It should be only used with linearized (not gamma
corrected) images that are normalized to the 0-1 range.
--quality <val>, -q <val>
Set JPEG/PNG compression level from 1 to 100. Default 75.
--bit-depth <val>, -b <val>
Enforce bit-depth (per color
channel). The allowed values are from 8 to 32. If not specified, the
bit depth from the pfs stream (BITDEPTH tag) will be used
instead. If the BITDEPTH tag is missing, the ImageMagick default
value will be used (usually 16). The bit depth of actually stored file
may be lower of that specified, if the file format does not support
higher bit depths.
pfsin test.jpg | pfsout test.png
Convert from one image format to another.
pfsin --linear test.jpg | pfsout --srgb test.png
The same as above, but apply inverse gamma correction after reading
an image (--linear) and then apply gamma correction before writing an
pfsoutimgmagick can not write frames to the standard output.
Please report bugs and comments on implementation to
the discussion group http://groups.google.com/group/pfstools
Visit the GSP FreeBSD Man Page Interface.
Output converted with manServer 1.07.