NAME

SYNOPSIS

DESCRIPTION

OPTIONS

-h

display help text

-o file

basename for the output file(s), a number and the .wav extension are added by record. Default is "record".

-i dev

mixer control. This should be the one where you can adjust the record level for your audio source. Default is "line". "mic" and "igain" are good candidates too. Best way to figure is to start your favorite mixer tool and check out which one works ...

-m dev

set mixer device. Default is "/dev/mixer".

-d dev

set audio device. Default is "/dev/dsp".

-r rate

set sample rate. Default is 44100.

-p sec

peak seconds (number of seconds which should be scanned for the volume maximum). This affects both peak level display and level triggered recording (see below). Default is 1.5 seconds.

record can also be used non-interactive:

-c

enable console (non-interactive) mode.

-v

be verbose (console mode only).

-t mm:ss

Limit the record time (console mode only). By default record records until stopped by a signal (by typing ^C for example).

-s size

Limit the file size (console mode only). record will continue with a new file once the limit is reached.

-n num

Limit the file count (console mode only). record will stop recording after num files.

-l

Enable level triggered recording (console mode only) with the default trigger level (1000).

-L level

Enable level triggered recording with the specified trigger level.

If level triggered recording is active, record will start and stop recording depending on the signal strength. Recording will be started if the signal strength is above the trigger level (1000/32768 => around 3%). Recording will be stopped if the signal is below the trigger level for some time (1.5 seconds by default, the -p switch changes this).

AUTHOR