Manual Reference Pages - RUBBER-INFO (1)
rubber-info - extract information from LaTeX documents
Rubber-info is a utility for extracting various kinds of information from a
LaTeX document. Information can be extracted from the source (for instance
when calculating dependencies) or from the compilation log files (to extract
errors and warnings). This program is a complement for the compilation system
The command-line options are those used by
plus one of the actions described below.
One of the following command-line options must be specified, to decide which
information to extract. Of course, for actions that read a log file, a
compilation must have been done before. If none of these actions is specified,
--check is assumed.
Extracts from the log file the places in the source where bad boxes appeared
(these are the famous overfull and underfull \hbox and \vbox)
Report errors if there are any, otherwise report undefined references if there
are any, otherwise list warnings and bad boxes. This is the default action.
Analyse the source files and produce a space-separated list of all the files
that the document depends on and that Rubber cannot rebuild.
Extract from the log file the list of errors that occured during the last
-h, --help ||
Display the list of all available options and exit nicely.
Report the list of undefined or multiply defined references (i.e. the \refs
that are not defined by one \label).
Analyse the source files and produce a list of dependency rules. One rule is
produced for each intermediate target that would be made when running
rubber. Rules are formatted in the style of Makefiles.
Print the version number and exit nicely.
Stupidly enumerate all LaTeX warnings, i.e. all the lines in the log file that
contain the string "Warning".
There are surely a some...
This page documents Rubber version 1.1. The program and this man-page are
maintained by Emmanuel Beffara <firstname.lastname@example.org>.
The homepage for Rubber can be found at
The full documentation for
rubber is maintained as a Texinfo manual. If the
rubber programs are properly installed at your site, the command
should give you access to the complete manual.
Visit the GSP FreeBSD Man Page Interface.
Output converted with manServer 1.07.