Manual Reference Pages - FPA (4)
- device drivers for DEC FDDI controllers
.Cd device fpa
.Cd device fea
.Cd device fddi
device drivers provide support for the DEC DEFPA PCI FDDI Controller and
the DEC DEFEA EISA FDDI Controller, respectively.
All variants of either
controller are supported including the DAS and SAS configurations.
| fea%d: error: desired IRQ of %d does not match devices actual IRQ (%d)
The device probe detected that the DEFEA board is configured for a different
interrupt than the one specified in the kernel configuration file.
| fea%d: error: memory not enabled! ECU reconfiguration required
The device probe found that no device memory had been configured on the
Although the DEFEA can be configured with no device memory, this driver
requires a minimum of 1K device memory to be set up.
The ECU (EISA Configuration
Utility) will need to be run to change the settings.
device drivers and this manual page were written by
.An Matt Thomas .
Normally, the device driver will not enable the reception of SMT frames.
However if the IFF_LINK1 flag is set, the device driver will enable the
reception of SMT frames and pass them up to the Berkeley Packet Filter for
Visit the GSP FreeBSD Man Page Interface.
Output converted with manServer 1.07.