Manual Reference Pages - SND_VIA8233 (4)
- VIA Technologies VT8233 bridge device driver
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
.Cd device sound
.Cd device snd_via8233
Alternatively, to load the driver as a module at boot time, place the
following line in
bridge driver allows the generic audio driver,
to attach to the VIA VT8233 audio devices.
These audio chipsets are integrated in the southbridge on many VIA based
variables are available in addition to those available to all
Experimental polling mode, where the driver operates by querying the device
state on each tick using
Polling is disabled by default.
Do not enable it unless you are facing weird interrupt problems or if the
device cannot generate interrupts at all.
driver supports the following audio chipsets:
- VIA VT8233
- VIA VT8233A
- VIA VT8233C
- VIA VT8235
- VIA VT8237
- VIA VT8251
device driver first appeared in
.Fx 4.7 .
This manual page was written by
.An Joel Dahl Aq joel@FreeBSD.org .
does not support S/PDIF.
There is partial support in the code, so implementing it should be fairly
easy if the right hardware is available.
Visit the GSP FreeBSD Man Page Interface.
Output converted with manServer 1.07.