|autoselect||Enable autoselection of the media type and options. Note that this option is only available on those PHYs that support autonegotiation. Also, the PHY will not advertise those modes that have been explicitly disabled using the following media options.|
|10baseT/UTP||Set 10Mbps operation.|
|100baseTX||Set 100Mbps (Fast Ethernet) operation.|
|10base5/AUI||Enable AUI/BNC interface (useful only with the built-in PHY).|
The tl driver supports the following media options:
|full-duplex||Force full duplex operation.|
|half-duplex||Force half duplex operation.|
|hw-loopback||Enable hardware loopback mode.|
Note that the 100baseTX media type is only available if supported by the PHY. For more information on configuring this device, see ifconfig(8).
The tl driver supports Texas Instruments ThunderLAN based Ethernet and Fast Ethernet adapters including a large number of Compaq PCI Ethernet adapters. Also supported are:
- Olicom OC-2135/2138 10/100 TX UTP adapter
- Olicom OC-2325/OC-2326 10/100 TX UTP adapter
- Racore 8148 10baseT/100baseTX/100baseFX adapter
- Racore 8165 10/100baseTX adapter
The tl driver also supports the built-in Ethernet adapters of various Compaq Prosignia servers and Compaq Deskpro desktop machines including:
- Compaq Netelligent 10
- Compaq Netelligent 10 T PCI UTP/Coax
- Compaq Netelligent 10/100
- Compaq Netelligent 10/100 Dual-Port
- Compaq Netelligent 10/100 Proliant
- Compaq Netelligent 10/100 TX Embedded UTP
- Compaq Netelligent 10/100 TX UTP
- Compaq NetFlex 3P
- Compaq NetFlex 3P Integrated
- Compaq NetFlex 3P w/BNC
tl%d: couldnt map memory A fatal initialization error has occurred. tl%d: couldnt map interrupt A fatal initialization error has occurred. tl%d: device timeout The device has stopped responding to the network, or there is a problem with the network connection (cable). tl%d: no memory for rx list The driver failed to allocate an mbuf for the receiver ring. tl%d: no memory for tx list The driver failed to allocate an mbuf for the transmitter ring when allocating a pad buffer or collapsing an mbuf chain into a cluster.
The tl device driver first appeared in
.Fx 2.2 .
The tl driver was written by
.An Bill Paul Aq firstname.lastname@example.org .