is the configuration file used by atalkd to configure the Appletalk interfaces and their behavior
Any line not prefixed with
is interpreted. The configuration lines are composed like:
The simplest case is to have either no atalkd.conf, or to have one that has no active lines. In this case, atalkd should auto-discover the local interfaces on the machine. Please note that you cannot split lines.
The interface is the network interface that this to work over, such as
for Linux, or
The possible options and their meanings are:
Allows specification of the net and node numbers for this interface, specified in Appletalk numbering format (example:
Disables Appletalk routing. It is the opposite of
Allows the available net to be set, optionally as a range.
-noallmulti (linux only)
On linux the interfaces, atalkd uses, are set to ALLMULTI by default caused by countless NICs having problems without being forced into this mode (some even don't work with allmulti set). In case, you've a NIC known to support multicasts properly, you might want to set this option causing less packets to be processed
-phase ( 1 | 2 )
Specifies the Appletalk phase that this interface is to use (either Phase 1 or Phase 2).
-seed, but allows single interface routing. It is the opposite of
The seed option only works if you have multiple interfaces. It also causes all missing arguments to be automagically configured from the network.
Specifies a specific zone that this interface should appear on (example:
-zone "Parking Lot"). Please note that zones with spaces and other special characters should be enclosed in parentheses.