Manual Reference Pages - WACKATRL (8)
wackatrl - IP-failover high-availability controller
wackatrl [-c config_file][-l|-f|-s]
wackatrl runs the wackatrl IP-failover HA controller and instructs the currently
running Wackamole instance to perform an action or display state information.
Use an alternate configuration file
config-file instead of
Lists the current state (ownership) of virtual interfaces.
Simulate a failure. The local instance will disconnect from Spread and
act as if it has failed by dropping its managed interfaces and running
whatever dynamic calls have been configured. A peer, should one exist,
will assume the responsibility for the interfaces that were dropped.
Recover from a simulated failure. This will tell the local instance to
stop simulating failure. The local instance will reconnect to Spread and
once again participate in the peer-based HA environment.
The default config file location is dependant on the install prefix.
./wackamole.conf is also searched if a local file is not found.
All error messages, should any be produced will be written to standard
No known bugs.
Theo Schlossnagle <firstname.lastname@example.org>
|Wackamole ||WACKATRL (8) ||May 2014 |
Visit the GSP FreeBSD Man Page Interface.
Output converted with manServer 1.07.