qlxgbe
— QLogic 10
Gigabit Ethernet & CNA Adapter Driver
To compile this driver into the kernel, place the following lines
in your kernel configuration file:
device qlxgbe
To load the driver as a module at boot time, place the following
line in
loader.conf(5):
The qlxgbe
driver supports IPv4 checksum
offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment
Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side
scaling, ability to select either HW or Software LRO, when LRO is enabled
(default HW LRO). For further hardware information, see
http://www.qlogic.com/.
The qlxgbe
driver supports 10 Gigabit
Ethernet & CNA Adapter based on the following chipsets:
For support questions please contact your QLogic approved reseller
or QLogic Technical Support at
http://support.qlogic.com, or by E-mail at
<support@qlogic.com>.
The qlxgbe
device driver first appeared in
FreeBSD 10.0.
The qlxgbe
driver was written by
David C Somayajulu at QLogic Corporation.