GSP
Quick Navigator

Search Site

Unix VPS
A - Starter
B - Basic
C - Preferred
D - Commercial
MPS - Dedicated
Previous VPSs
* Sign Up! *

Support
Contact Us
Online Help
Handbooks
Domain Status
Man Pages

FAQ
Virtual Servers
Pricing
Billing
Technical

Network
Facilities
Connectivity
Topology Map

Miscellaneous
Server Agreement
Year 2038
Credits
 

USA Flag

 

 

Man Pages
QLXGE(4) FreeBSD Kernel Interfaces Manual QLXGE(4)

qlxge
QLogic 8100 Series 10 Gigabit Ethernet Adapter Driver

To compile this driver into the kernel, place the following lines in your kernel configuration file:
device qlxge
To load the driver as a module at boot time, place the following line in loader.conf(5):
if_qlxge_load="YES"

The qlxge driver supports IPv4 checksum offload, TCP and UDP checksum offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling. For further hardware information, see http://www.qlogic.com/.

The qlxge driver supports 10 Gigabit Ethernet & CNA Adapter based on the following chipsets:
  • QLogic 8100 series

For support questions please contact your QLogic approved reseller or QLogic Technical Support at http://support.qlogic.com, or by E-mail at <support@qlogic.com>.

altq(4), arp(4), netintro(4), ng_ether(4), ifconfig(8)

The qlxge device driver first appeared in FreeBSD 10.0.

The qlxge driver was written by David C Somayajulu at QLogic Corporation.
June 21, 2013 FreeBSD 12.0-RELEASE

Search for    or go to Top of page |  Section 4 |  Main Index

Powered by GSP Visit the GSP FreeBSD Man Page Interface.
Output converted with ManDoc.