ospf6d - an OSPF routing engine for use with Zebra and IPv6
ospf6d [
-dhv ] [
-f config-file ] [
-i pid-file ] [
-P port-number ]
ospf6d is a routing component that works with the
zebra routing
engine.
ospf6d.
- -d, --daemon
- Runs in daemon mode, forking and exiting from tty.
- -f, --config-file config-file
- Specifies the config file to use for startup. If not specified this option
will likely default to /usr/local/etc/ospf6d.conf.
- -h, --help
- A brief message.
- -i, --pid_file pid-file
- When ospf6d starts its process idenifier is written to
pid-file. The init system uses the recorded PID to stop or
restart ospf6d. The likely default is /var/run/ospf6d.pid.
- -P, --vty_port port-number
- Specify the port that the ospf6d VTY will listen on. This defaults to
2606, as specified in /etc/services.
- -v, --version
- Print the version and exit.
router ospf6 router zebra -- (Move routes into kernel table)
network [NETWORK] area [OSPF6-AREA-ID] no network [NETWORK]
show ip ospf6 interface show ip ospf6 neighbor show ip
ospf6 database show ip ospf6 route
debug ospf6 ism debug ospf6 packet debug ospf6 nsm
- /usr/local/sbin/ospf6d
- The default location of the ospf6d binary.
- /usr/local/etc/ospf6d.conf
- The default location of the ospf6d config file.
- $(PWD)/ospf6d.log
- If the ospf6d process is config'd to output logs to a file, then
you will find this file in the directory where you started ospf6d.
This man page is intended as a quick reference for command line options, and for
config file commands. The definitive document is the Info file
zebra.
The ospf6d process may log to standard output, to a VTY, to a log file, or
through syslog to the system logs.
ospf6d supports many debugging
options, see the Info file, or the source for details.
References to other related man pages:
ripd(8), ripngd(8), ospfd(8), bgpd(8), zebra(8), vtysh(1)
ospf6d eats bugs for breakfast. If you have food for the maintainers try
<bug-zebra@gnu.org>
See <
www.zebra.org>, or the Info file for an accurate list of
authors.